Gigabyte AMD Socket AM2 Processor Motherboard GA-M55S-S3 Manuel d'utilisateur télécharger pdf (Page 76)

GA-M55S-S3 (rev. 2.0) Motherboard - 76 -

English

After the SATA controller driver installation is completed, you can proceed with the Windows 2000/XP

installation.

Figure 18

(Note: Each time you add a new hard drive to a RAID array, the RAID driver will have to be installed

under Windows once for that hard drive. After that, the driver will not have to be installed.)

Step 4:

When the next screen (Figure 17) appears, press ENTER to continue the SATA driver installation from

the floppy disk.

Figure 17

Windows Setup

S=Specify Additional Device ENTER=Continue F3=Exit

Setup will load support for the following mass storage device(s):

NVIDIA RAID CLASS DRIVER (required)

NVIDIA NForce Storage Controller (required)

* To specify additional SCSI adapters, CD-ROM drives, or special

disk controllers for use with Windows, including those for

which you have a device support disk from a mass storage device

manufacturer, press S.

* If you do not have any device support disks from a mass storage

device manufacturer, or do not want to specify additional

mass storage devices for use with Windows, press ENTER.

WindowsXP Professional Setup

Enter= Continue R=Repair F3=Exit

Welcome to Setup.

This port of the Setup program prepares Microsoft(R)

Windows (R) XP to run on your computer.

To set up Windows XP now, press ENTER.

To repair a Windows XP installation using

Recovery Console, press R.

To quit Setup without installing Windows XP, press F3.

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 87 88

Pas de commentaire

Gigabyte AMD Socket AM2 Processor Motherboard GA-M55S-S3 Manuel d'utilisateur Page 76