Gigabyte AMD Socket AM2 Processor Motherboard GA-M55S-S3 Manuel d'utilisateur télécharger pdf (Page 67)

Appendix- 67 -

English

(Note) Skip this step if you do not want to create RAID array on the SATA controller.

To configure SATA hard drive(s), follow the steps below:

(1) Install SATA hard drive(s) in your system.

(2) Configure SATA controller mode and boot sequence in BIOS Setup.

(3) Configure RAID set in RAID BIOS.

(Note)

(4) Make a floppy disk containing the SATA controller driver.

(5) Install the SATA controller driver during OS installation.

Before you begin

Please prepare:

(a) At least two SATA hard drives (to ensure optimal performance, it is recommended that you use two

hard drives with identical model and capacity). If you do not want to create RAID, you may prepare

only one hard drive.

(b) An empty formatted floppy disk.

(d) Driver CD for your motherboard.

(1) Installing SATA hard drive(s) in your computer

Attach one end of the SATA signal cable to the rear of the SATA hard drive and the other end to available

SATA port(s) on the motherboard. Then connect the power connector from your power supply to the

hard drive.

4-1-4 Configuring SATA Hard Drive(s)

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 87 88

Pas de commentaire

Gigabyte AMD Socket AM2 Processor Motherboard GA-M55S-S3 Manuel d'utilisateur Page 67