Gigabyte GA-970A-UD3 Manuel d'utilisateur télécharger pdf (Page 20)

Hardware Installation - 20 -

In addition to the default speakers settings, the ~ audio jacks can be recongured to perform

different functions via the audio software. Only microphones still MUST be connected to the

default Mic in jack ( ). Refer to the instructions on setting up a 2/4/5.1/7.1-channel audio con-

guration in Chapter 5, "Conguring 2/4/5.1/7.1-Channel Audio."

Center/Subwoofer Speaker Out Jack (Orange)

Use this audio jack to connect center/subwoofer speakers in a 5.1/7.1-channel audio conguration.

Rear Speaker Out Jack (Black)

Use this audio jack to connect rear speakers in a 4/5.1/7.1-channel audio conguration.

Side Speaker Out Jack (Gray)

Use this audio jack to connect side speakers in a 7.1-channel audio conguration.

Line In Jack (Blue)

The default line in jack. Use this audio jack for line in devices such as an optical drive, walkman, etc.

Line Out Jack (Green)

The default line out jack. Use this audio jack for a headphone or 2-channel speaker. This jack can be

used to connect front speakers in a 4/5.1/7.1-channel audio conguration.

Mic In Jack (Pink)

The default Mic in jack. Microphones must be connected to this jack.

When removing the cable connected to a back panel connector, rst remove the cable from your •

device and then remove it from the motherboard.

When removing the cable, pull it straight out from the connector. Do not rock it side to side to •

prevent an electrical short inside the cable connector.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 99 100

Pas de commentaire

Gigabyte GA-970A-UD3 Manuel d'utilisateur Page 20