Gigabyte GA-970A-UD3 Manuel d'utilisateur télécharger pdf (Page 75)

- 75 - Appendix

Chapter 5 Appendix

5-1 Conguring SATA Hard Drive(s)

To congure SATA hard drive(s), follow the steps below:

A. Install SATA hard drive(s) in your computer.

B. Congure SATA controller mode in BIOS Setup.

C. Congure a RAID array in RAID BIOS.

(Note 1)

D. Install the SATA RAID/AHCI driver

(Note 2)

and operating system.

Before you begin

Please prepare:

• At least two SATA hard drives (to ensure optimal performance, it is recommended that you use two hard

drives with identical model and capacity). If you do not want to create RAID, you may prepare only one

hard drive.

• Windows 7/Vista/XP setup disk.

• Motherboard driver disk.

• A USB oppy disk drive (needed during Windows XP installation)

• An empty formatted oppy disk (needed during Windows XP installation)

5-1-1 Conguring SATA Controllers

A. Installing SATA hard drive(s) in your computer

Attach one end of the SATA signal cable to the rear of the SATA hard drive and the other end to available

SATA port on the motherboard. Then connect the power connector from your power supply to the hard drive.

(Note 1) Skip this step if you do not want to create RAID array on the SATA controller.

(Note 2) Required when the SATA controller is set to AHCI or RAID mode.

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 99 100

Pas de commentaire

Gigabyte GA-970A-UD3 Manuel d'utilisateur Page 75