Gigabyte AMD Socket 939 Processor Motherboard GA-K8NF-9-RH Manuel d'utilisateur télécharger pdf (Page 65)

Appendix- 65 -

English

4-1-4 Configuring SATA Hard Drive(s)

To configure SATA hard drive(s), follow the steps below:

(1) Install SATA hard drive(s) in your system.

(2) Configure SATA controller mode and boot sequence in BIOS Setup.

(3) Configure RAID set in RAID BIOS.

(Note)

(4) Make a floppy disk containing the SATA controller driver.

(5) Install the SATA controller driver during OS installation.

Before you begin

Please prepare:

(a) Two SATA hard drives (to ensure optimal performance, it is recommended that you use two hard

drives with identical model and capacity). If you do not want to create RAID with the SATA

controller, you may prepare only one hard drive.

(b) An empty formatted floppy disk.

(d) Driver CD for your motherboard.

(1) Install SATA hard drive(s) in your system

Attach one end of the SATA signal cable to the rear of the SATA hard drive and the other end to available

SATA port(s) on the motherboard. Then connect the power connector from your power supply to the

hard drive.

(Note) Skip this step if you do not want to create RAID array on the SATA controller.

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 87 88

Pas de commentaire

Gigabyte AMD Socket 939 Processor Motherboard GA-K8NF-9-RH Manuel d'utilisateur Page 65