Gigabyte GA-P55A-UD3 Manuel d'utilisateur télécharger pdf (Page 93)

- 93 - Appendix

Now, you may proceed to create the SATA driver diskette (for AHCI mode) and the installation of the SATA

driver and operating system.

Delete the RAID Array:

To deleted the existing array, select the array on the main menu (example: VD 0: New_VD) and press <En-

ter> to display the Deleteoption.Press<Enter>.Whenprompted,press<Y>toconrmor<N>tocancel(Figure

8).

Figure 8

Topology Information

Help

Vendor ID : 1B4B

Device ID : 91A3

Revision ID : B1

BIOS Version : 1.0.0.1006

Firmware Version : 2.1.0.1314

PCIe Speed rate : 2.56Gbps

CongureSATAas : IDEMode

HBA 0 : Marvell 0

Virtual Disks

VD 0: New_VD

PD 0: WDC WD800JD-22L

Free Physical Disks

Marvell RAID on chip controller.

ENTER: Operation F10: Exit/Save ESC: Return

Do you want to delete this virtual disk?

Yes No

Delete Virtual Disk

Use the Marvell RAID Utility in the Operating System:

With the Marvell RAID utility, you can set up an array or view the current array status in the operating system.

To install the utility, insert the motherboard driver disk, then go to Application Software\Install GIGABYTE

Utilities and select Marvell Raid Utility to install. Note: After the installation, you must login the utility with

the same account name and password that you use to login the operating system. If you did not set the

account password before, click Login to enter the Marvell RAID Utility directly.

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 119 120

Pas de commentaire

Gigabyte GA-P55A-UD3 Manuel d'utilisateur Page 93